The so-called wave cultivation mode, that is, when planting material, the bed of culture material is designed as a undulating peaks and troughs, the shape of the surface waves. The greatest advantage of this cultivation mode is that: Firstly, the surface area of ​​the mushroom surface is increased, and the area of ​​mushroom growth is increased by more than 50% compared with the surface area of ​​the flat cultivation bed. The second is to effectively regulate the microclimate environment within the bed and material. In ventilating oxygen supply, eliminating hazardous gases in the material, regulating the temperature of the material, etc., are superior to the plane cultivation method. Third, under the premise of not increasing any investment, the yield per unit area cultivated can be increased by 30% to 40%, the bioconversion rate of raw materials can be significantly increased, and the economic benefits can be significantly increased.
Operational methods: Production procedures such as batching, fermentation, cultivation and disinfection of cultivation sites, and various management tasks during the latter stages of cultivation are the same as those for conventional cultivation methods. The difference lies in: First, the width of the car is designed to be 120 centimeters, which will help improve the utilization of ordinary agricultural films. The second is the use of stratified sowing, that is, 2 layers of 2 layers of seed to accelerate the speed of bacterial growth. The third is to spread three 30-cm-wide materials in a vertical direction on the car surface at the time of planting sowing. The material thickness is 10 centimeters, and two voids each of 15 centimeters in width are not paved. After the material level is slightly flattened, sowing with a seed amount of 1/3 of the species, and then in the material surface and then spread a layer of 15 cm thick material, will be reserved at the gap of 3 cm thick material, and then immediately material finishing In a semi-circular shape (turtle shape), it forms peaks and troughs, with a peak height of 22 cm and a bottom width of 15 cm. Finally, the remaining 2/3 of the strains were evenly spread on the material surface, gently patted with a wooden board, covered with film, straw curtain, heat preservation and moisturizing, bacteria administration. After about 15 to 20 days, half of the material in the material or 2/3 of the material is covered in the material, and the artificially improved soil is covered in time. When the soil is covered, the thickness of the crests and troughs should reach 5 cm. 15 to 18 days after covering the soil, a large number of mushrooms can be produced in the crests and troughs. Tests have shown that when the soil thickness of Coprinus comatus is about 5 cm, the grown mushrooms are hypertrophic, the stems are short, the parachute is short, the production is high, the quality is good, and the price is high and they sell well.
Operational methods: Production procedures such as batching, fermentation, cultivation and disinfection of cultivation sites, and various management tasks during the latter stages of cultivation are the same as those for conventional cultivation methods. The difference lies in: First, the width of the car is designed to be 120 centimeters, which will help improve the utilization of ordinary agricultural films. The second is the use of stratified sowing, that is, 2 layers of 2 layers of seed to accelerate the speed of bacterial growth. The third is to spread three 30-cm-wide materials in a vertical direction on the car surface at the time of planting sowing. The material thickness is 10 centimeters, and two voids each of 15 centimeters in width are not paved. After the material level is slightly flattened, sowing with a seed amount of 1/3 of the species, and then in the material surface and then spread a layer of 15 cm thick material, will be reserved at the gap of 3 cm thick material, and then immediately material finishing In a semi-circular shape (turtle shape), it forms peaks and troughs, with a peak height of 22 cm and a bottom width of 15 cm. Finally, the remaining 2/3 of the strains were evenly spread on the material surface, gently patted with a wooden board, covered with film, straw curtain, heat preservation and moisturizing, bacteria administration. After about 15 to 20 days, half of the material in the material or 2/3 of the material is covered in the material, and the artificially improved soil is covered in time. When the soil is covered, the thickness of the crests and troughs should reach 5 cm. 15 to 18 days after covering the soil, a large number of mushrooms can be produced in the crests and troughs. Tests have shown that when the soil thickness of Coprinus comatus is about 5 cm, the grown mushrooms are hypertrophic, the stems are short, the parachute is short, the production is high, the quality is good, and the price is high and they sell well.
Dried Squids,Dried Cuttlefish,Dehydrated Squid,Dry Calamari
Zhoushan Fudan Tourism CO., LTD , https://www.fudanfood.com