How to choose the right slaughtering equipment? Choosing a slaughtering equipment should not be done blindly. From the mission principle of the slaughtering equipment, for example, a set of poultry slaughtering equipment, it is mainly composed of a scalding pool, a hair removal machine, and a spiral cold machine.
The immersion pool of the slaughtering equipment is important to make the water outside the scalding pool flow through the blower, and heat the birds. After the motor drives the propeller to pump the water outside the scalding pool and scouring it, the local curvature of the hot pool is not too small. If it is too small, it will affect the temperature of heating the birds. It is not easy to be too large. It should be between 140-150 degrees. Some manufacturers in the lower part of the propeller are welded into a cone type, and some manufacturers are welded to form a body. Regardless of the shape, the spacing should not be greater than 4 cm.
The slope of the T-shaped steel at the front of the pool must be steep. Otherwise, the chain from the upper part will have a certain impact on the front end of the hot pool. If it is long, it will affect the life of the sprocket.
From the hot pool, the next step is to enter the hair removal machine. Whether it is a vertical hair removal machine or a horizontal hair removal machine, the motor is used to drive the glue stick to perform a continuous alternating blow to the birds, and the hair is knocked off. Go out from the discharge port, so you must pay attention to the quality of the glue stick when purchasing the hair removal machine. The soft and hard must be moderate. If you look at the appearance for the first time, see if the glue stick can be the same, can you have the glue stick? The gap between the glue stick and the glue stick is too small. It should also be noted that waterproofing equipment must be added to the outside of the hair removal machine to prevent the water from spilling out and affect the life of the rolling shaft bearing.
In the end, the spiral of the slaughtering equipment is cold. The important thing is to treat the cold-headed birds in the front-end process with cold, and deacidification together. When the rotor of the pre-cooler rotates, the friction of the pre-cooler body must not occur, and the rotor must not be partially deformed. It is necessary to carry out double-sided welding as part of the load-bearing part.
Flame Retardant Net,Fire-Retardant Insect Screen,Flame Retardant Climate Screen,Shading Aluminum Thermal Screen
Changzhou Green Nets Co.,Ltd. , https://www.czglnets.com